International Coatings 156 Silver Shimmer Plastisol
Metallic Shimmers are bleed resistant Shimmer Plastisols that are press ready.
Metallic Shimmers are used to produce a bright, sparkled look when printed.
Metallic Shimmers consist of a fine, shimmering glitter flakes in a low bleed, low fusion, easy to print base.
Metallic Shimmers can be printed onto a garment as is, or printed over other colors to highlight areas of a design. When printing multiple colors, Shimmers should be printed last. Shimmers should be printed without any modifications. If modification is necessary use the following reducer: 1099 Low Bleed Curable Reducer (Add 1% to 5% by weight).
Use International Coatings’ 7500 Series Fluorescents or Process Colors for tinting Shimmer to other shades. Do not mix Shimmers with opaque inks as they will block out or cover the Metallic Shimmers flake.
For better adhesion on some fabrics it may be necessary to add the 900 Catalyst for proper adhesion. The ratio of ink to catalyst is 16 parts ink to 1 part catalyst by volume and 20 to 1 by weight.
The Metallic Shimmers have good opacity on dark fabrics. However, in some instances, when printing through finer mesh counts, double hits with or without a flash may be needed. This is especially true when printing 157 or 158 Metallic Shimmers on dark fabrics.
Print Metallic Shimmers last in the design to avoid excessive pick-up of the shimmer flakes.
The time/temperature cycle is very important when printing through very open mesh screens. It may take the thicker ink film a little longer to reach the proper fusion temperature than a standard ink. Always test for proper fusing before and during a production run.
Some 100% Polyesters
86-110 t/in (34-63 t/cm) monofilament
60-70 Durometer Sharp edge
STORAGE OF INK CONTAINERS
65º to 90ºF (18ºC to 32ºC) Avoid storage in direct sunlight. Keep containers well sealed
Feel free to live chat with us if you have any questions.